Logical switch function on fcip tunnels dialog box, Adding an fcip circuit, Eps under and – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 884
836
Brocade Network Advisor SAN User Manual
53-1002948-01
Adding an FCIP circuit
22
The Edit FCIP Tunnel dialog box displays. This dialog box allows you to edit configurations
on both switches on either end of the tunnel.
A Circuits properties table displays at the bottom of the dialog box. For 8 Gbps platforms,
this may contain columns for multiple circuits. Actual, as well as cached circuits display.
You can configure circuits using the Add, Edit, Delete, Enable, and Disable circuits using
the function buttons to the right of the table. For 4 Gbps platforms, the Delete, Enable, and
Disable buttons do not display. In addition, the Edit operation is only supported for cached
circuits.
c. Change configuration settings as required using the following steps.
4. To add a circuit, click Add to the right of the Circuits properties table at the bottom of the dialog
box.
The Add FCIP Circuit dialog is displayed. Continue with
.
Logical switch function on FCIP Tunnels dialog box
Display and function of tunnels and circuits created on logical switches and with shared GigE ports
varies on the FCIP Tunnels dialog box according to the discovery of the default switch and
user-configured logical switches as follows. If default and user-user-configured logical switch are
discovered, all tunnels and circuits created on logical switch display, including circuits with shared
GbE ports.
•
If the user-configured logical switch is discovered and the default logical switch is not
discovered, the circuits and tunnels with shared GigE ports will be listed in the tunnel, but they
cannot be edited or deleted.
•
In a fabric with two logical switches that have a shared GigE port and only the default logical
switch for one logical switch is discovered, the circuits and tunnels with shared GigE ports will
be listed in the tunnel, but they cannot be edited or deleted.
For details on configuring FCIP with logical switches, use the following references:
•
“Using FCIP with logical switches” section in the Fabric OS FCIP Administrator’s Guide.
•
Adding an FCIP circuit
When adding a new FCIP tunnel, you can add an FCIP circuit by selecting the Add button to the right
of the Circuits properties table on the Add FCIP Tunnel dialog box (
Figure 362
on page 835). For 8
Gbps platforms, you can add multiple FCIP circuits to the tunnel with this button.
Add circuits to existing FCIP tunnels through the Edit FCIP Tunnel dialog box. To display this dialog
box, right-click a tunnel on the FCIP Tunnels dialog box and select Edit Tunnel or select a tunnel and
click the Edit button. For details, refer to