Top port crc errors monitor – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 250
200
Brocade Network Advisor SAN User Manual
53-1002948-01
Performance monitors
7
Top Port CRC Errors monitor
The Top Port CRC Errors monitor (
) displays the top ports with frames that contain cyclic
redundancy check (CRC) errors in a table.
FIGURE 68
Top Port CRC Errors monitor
The Top Port CRC Errors monitor includes the following data:
•
Severity icon/monitor title — The worst severity of the data based on the error count shown
next to the monitor title.
•
Port — The port affected by this monitor.
•
Connected_Port_Link (where Connected_Port_Link is Connected Port, Initiator, or Target) —
Displays one of the following:
-
Connected Port — The ISL or IFL port on the connected device. Click to launch the switch
port properties dialog box.
-
Initiator — The initiator port on the connected device. Click to launch the device properties
dialog box.
-
Target — The target port on the connected device. Click to launch the device properties
dialog box.
•
CRC Errors/sec — The number (error rate) of cyclic redundancy check (CRC) errors per second
for the duration specified in the monitor.
•
CRC Errors — The number (error count) of cyclic redundancy check (CRC) errors for the duration
specified in the monitor.
•
Product — The product affected by this monitor.
•
Type — The type of port (for example, U-Port).
•
Identifier — The port identifier.
•
Port Number — The port number.
•
State — The port state (for example, Enabled).