Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 1117)

1070 Brocade Network Advisor SAN User Manual
53-1002948-01
Adding a policy monitor
32
FIGURE 447 Add Policy Monitor dialog box, Fabric Checks tab
3. Enter a user-defined name for the policy in the Name field.
The name must be unique. It cannot be over 64 characters, nor can the field be empty. It
cannot include asterisks.
4. Enter a description of the policy in the Description field.
The description cannot be over 128 characters. It cannot include asterisks.
5. Click the Schedule Use check box and choose one of the following options:
• To use the default frequency (one time, runs at current system time plus fifteen minutes),
go to
step 6 .
• To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the policy monitor:

To configure deployment to run only once, refer to “Configuring a one-time policy
monitor schedule” on page 1075.

To configure hourly deployment, refer to “Configuring an hourly policy monitor
schedule” on page 1075.

To configure daily deployment, refer to “Configuring a daily policy monitor schedule”
on page 1075.