Adding an encryption target – Brocade Network Advisor SAN User Manual v12.1.0 User Manual
Page 732
684
Brocade Network Advisor SAN User Manual
53-1002948-01
Configuring encryption storage targets
20
5. Confirmation
6. Configuration Status
7. Important Instructions
Adding an encryption target
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to
Figure 196
on page 566.)
2. Select a group, switch, or engine from the Encryption Center Devices table to which to add the
target, then select Group/Switch/Engine > Targets from the menu task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to
Figure 297
.)
FIGURE 297
Encryption Targets dialog box
3. Click Add.
The Configure Storage Encryption wizard welcome screen displays. (Refer to
Figure 298
.)