Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 710)

662 Brocade Network Advisor SAN User Manual
53-1002948-01
Creating a new encryption group
20
Configuring key vault settings for IBM Tivoli Key Lifetime Manager
(TKLM)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
“Creating a new encryption group”
on page 636.
Figure 274 shows the key vault selection dialog box for TKLM.
FIGURE 274 Select Key Vault dialog box for TKLM
1. Enter the IP address or host name for the primary key vault.
2. Enter the name of the file that holds the primary key vault’s public key certificate or browse to
the desired location.
3. If you are using a backup key vault, enter the IP address or host name, and the name of the file
holding the backup key vault’s public key certificate in the fields provided.
4. Click Next.
The Specify Master Key Certificate File Name dialog box displays. (Refer to Figure 276 .)