Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 537)

Brocade Network Advisor SAN User Manual 489
53-1002948-01
DCB configuration
16
8. Click Start on the Deployment Status dialog box to save the changes to the selected port or
ports.
9. Click Close to close the Deployment Status dialog box.
Editing a LAG
Use the following procedure to change members and policies in a link aggregation group (LAG).
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select the link aggregation group (LAG) from the Products/Ports list.
3. Click Edit.
The Edit LAG dialog box displays, as shown in Figure 167 .
FIGURE 167 Edit LAG dialog box
4. Configure the following LAG parameters, as required:
NOTE
Ports with 802.1x authentication or ports that are enabled in L2 mode or L3 mode are not
supported in a LAG.
• LAG ID - The LAG identifier, which is not an editable field.
• Status - Click the Enable check box to enable the LAG. You must enable the LAG to use the
DCB functionality.
• Interface Mode - Select None or L2. For external ports, the L3 interface mode displays, in
addition to None or L2. If you select L3 as the interface mode, the IP/Netmask field is
enabled and you can then assign the primary and secondary IP addresses.