Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 988)

940 Brocade Network Advisor SAN User Manual
53-1002948-01
VLAN routing
26
FIGURE 410 Virtual Port - IP Configuration dialog box
3. Complete one of the following steps:
- To add a new IP address to the SVI, enter the IP address in the IP Address field and click
the right arrow button to move it to the Selected IP Addresses list.
- To modify an IP address of an SVI, select the IP address from the list and click the left
arrow button to move the IP address back to the IP Parameters list. Because this list is for
a single IP address, multiple IP addresses cannot be edited.
4. Enter the following information:
- Primary or Secondary options (DCB products only) — Indicates whether the IP address is
the primary or secondary IP address of the VLAN.
- Type — Select the type of IP address you want to assign to the VLAN. Choose CIDR or
IP/Subnet.
- Enter the IP address in the fields provided:
• If you chose the CIDR format, enter a subnet address in the
subnet_address/subnet_mask_bits format (for example, 192.168.2.10/24).
• If you chose the IP/Subnet format, enter a subnet address in the
subnet_address/subnet_mask format (for example, 192.168.2.10/255.255.255.0).
5. Click the right arrow button to add the IP address to the Selected IP Addresses list. If additional
IP addresses are needed, continue adding them to the SVI and VE. You can assign a maximum
of 255 IP addresses on DCB products and a maximum of 24 IP addresses on IOS products.
6. Click OK to begin the deployment of the address to the product.
The Deploy IP Configuration dialog box displays ( Figure 411 ).
FIGURE 411 Deploy IP Configuration dialog box