Brocade Network Advisor SAN User Manual v12.1.0 - Manual (Page 447)

Brocade Network Advisor SAN User Manual 397
53-1002948-01
Ports
12
1-MAC Address The media access control (MAC) address of the first switch.
1-IP Address The IP address of the first switch.
1-Speed (Gbps) The speed of the first switch.
1-Trunk Whether there is a trunk on the first switch.
1-Tunnel ID The tunnel ID of the first switch.
1-Circuit ID The circuit ID of the first switch.
2-Port # The port number of the second switch.
2-Port Type The port type of the second switch.
2-WWPN The world wide port number of the second switch.
2-MAC Address The MAC address of the second switch.
2-IP Address The IP address of the second switch.
2-Trunk Whether there is a trunk on the second switch.
2-Speed (Gbps) The speed of the second switch.
2-Tunnel ID The tunnel ID of the second switch.
2-Circuit ID The circuit ID of the second switch.
dB Loss (dB) The power loss (dB) value between the source and destination ports.
Only available when historical performance data collection is
enabled.
For Fabric OS devices, this field requires firmware version 6.2.2d,
6.3.2c, 6.4.1a, or 6.4.2 or later.
Does not display in Professional edition or if SNMP commnunication
fails during discovery or if either switch is not reachable through ISL
or IFL.
Selected Connection Properties table The connected device port information.
Area ID (hex)/Port Index (hex) The area identifier, in hexadecimal, of the switch-to-product
connection.
Blocked The configuration of the switch (blocked or unblocked).
Buffers Allocated The number of buffers allocated.
Buffers Desired The number of buffers required but not allocated.
Circuits The circuit number of the connected switch.
Compression Whether compression is enabled or disabled.
Connected Switch The name of the connected switch.
Cost The cost of the ISL link.
Distance Actual (km) The actual distance (in km) for -end port connectivity.
Distance Estimated (km) The estimated distance (in km) for -end port connectivity.
ED TOV The Error Detect timeout value, in milliseconds, of the connected
switch. This variable is used to flag a potential error condition when
an unexpected response is not received.
Encryption Whether encryption is enabled or disabled.
TABLE 48 Port connection properties (Continued)
Field Description