HT instruments SOLAR300N - Manual (Page 90)

SOLAR300 - SOLAR300N
EN - 88
5.6. START A RECORDING
The meter is designed to start a recording in MANUAL or AUTOMATIC mode (the
Automatic only for NPV systems - see § 5.4.2.3) by pressing of GO/STOP key. A recording
operation can be started exclusively under the following screens:
 GENERAL MENU (with any selected icon)
 Real time values (in any internal screen)
12/09/2006 – 16:55:10
GENERAL MENU
Meter information
12/09/2006 – 16:55:10
SCOPE VOLTAGES – Page 1/5
Fs 400.0V
V1 223.4V
V2 228.5V
V3 225.7V
Vn 0.0V
PAGE
Fig. 142: Example of screens for recording starting
Before starting a recording press ESC key (or the smart icon ) until you get a picture as
shown in Fig. 142.This operation can be performed in the below ways:
 MANUAL: Recording will start at the following minute after pressing GO/STOP key.
 AUTO:
Only if the instrument is configured for NPV systems: When pressing the
GO/STOP key (necessary), the instrument remains in stand-by until
reaching the date/time set (see § 5.4.2.2) to start recording.
The waiting and recording run status are marked by meter with dedicated icons which are
present on the top right of display, as shown in below picture:
Fig. 143: Meter waiting for recording
12/09/2006 – 16:55:10
GENERAL MENU
Meter information
12/09/2006 – 16:55:10
GENERAL MENU
Meter information
Fig. 144: Meter in recording run
Press again GO/STOP key to stop the recording run in any time. The icon shown in Fig.
144 disappear.