Auerswald 2500 - Manual (Page 100)

Use of the Telephone and PBX System
Ringer Signal
100
Use Function via Key:
By pressing the key the acoustical ringer signal is switched on, off or over.
By pressing the key during an inbound call the acoustic ringer signal is immediately switched
on, off or over for this call.
LED Signalling next to the Key:
If you need a more noticeable signalling when the acoustic ringer signal is switched off, calls
can be signalled by a flashing display backlight (see next chapter).
If you do not like to switch off the ringer signal completely but to switch on a slight attention
acoustic ringer signal, select the setting “single ringer tone” (see
page 172 ).
Signal Calls via flashing Display Backlight (Ringer Signal/Light) 14
If the surrounding must not be disturbed by the ringing of the telephone, you can signal calls
via blinking of the display backlight instead (in addition to other visual signals). Dependent on
the room brightness a very noticeable visual signalling is possible.
Use the Function via Function Menu:
The current settings for the key
assignment is shown on the
display.
If you like to change the current settings, press
the softkey in front of the corresponding
selection once or several times (You will find
help on
page 155 and the following):
ț [switching type]: Enables the assignment
with switch on, off or over.
Press the softkey to complete the settings.
off The acoustic ringer signal is switched on.
red The acoustic ringer signal is switched off.
☞
Advice
14 not on COMfortel 1500
Open the function menu for the function “ringer
backlight” (You will find help on
page 33 and
the following).
functions
ringer backlight
The icon marks the current
setting.
Press the softkey to the left of the option
you require:
ț activating: Switch on the flashing display
lighting and switch off the acoustical ringer
signal at the same time.
ț switching off: Switch off the flashing display
lighting and switch on the acoustical ringer
signal on at the same time.
...