Auerswald 2500 - Manual (Page 181)

Service Functions
181
S ERVICE F UNCTIONS
Start an Automatic Firmware Update
An update of the firmware of the telephone e.g. could make sense if additional features are
offered. Contact your dealer whether an update is a benefit for you. Or stay informed about
improvements in the telephone software - on our homepage in the Internet. The version
number of the software in your telephone can be viewed as described in the
chapter View
Information on Telephone and PBX on page 185 .
If the update is started as described in the following, the telephone will be connected to the
stated server to receive the current software from there (the settings of the telephone remain
unchanged). The update is free of charge: Only the charges for the necessary telephone con-
nection have to be paid.
Please enter the external telephone number always with the exchange line access number
“0”. (Exceptions: Direct Exchange Line Telephone; see
page 56 .)
In the configuration programme COMset of the PBX an automatic update of all connected
system telephones can be configured additionally. This way an update is regularly done (e.g.
annually) “via exchange line” with one system telephone and the new firmware is “distributed”
to the other system telephones then. (The update time is freely selectable in COMset and is
preferably done at night. - On the display of the distributing system telephone “Server Mode”
is shown during the distribution process. In this time an operation is not possible.
Open the settings menu for the setting
“Firmware Update” (You will find help on
page 33 and the following).
settings
synchronization
firmware update
The server number has been
entered with the PC pro-
gramme COMfortel Set.
N
0053069200510_
Change the server telephone number if nec-
essary.
Press the softkey to complete the entry.
The firmware update is made.
Afterwards is displayed if the
update was successful.
Press the softkey to confirm the message.
☞
Important
☞
Advice