Make a call, Telephone with comfort, Handsfree operation – Auerswald 2500 User Manual
Page 38: Switch on/off speaker mode
Make a Call
38
M
AKE
A
C
ALL
Telephone with Comfort
Handsfree Operation
In case of handsfree operation the loudspeaker and the microphone are switched on in the
device. This way you can make a call although you do not have any free hand. Besides this
another person in the room can take part in the call.
During a call you can activate loudspeaker and microphone in the device by pressing the
loudspeaker key (approx. 2 seconds) (see
). In this mode the micro-
phone of the receiver is switched off but the loudspeaker of the receiver stays active.
During the connection setup the handsfree operation can be switched on with the hook
key as well as with the loudspeaker key (see
). The same way you can
also terminate the call.
During handsfree operation the following symbol is presented on the display:
.
With help of the plus/minus keys you can change the volume in the loudspeaker during the
handsfree operation.
In case of headset operation there are some differences to this usage because the hook key
is needed for the starting and finishing of a headset call (see
Switch on/off Speaker Mode
In the speaker mode the loudspeaker in the device is switched on in addition to the loud-
speaker and microphone in the receiver. Due to this you can enable a person in the room to
listen to the call, too. You will continue the call via the receiver (no handsfree operation).
You can switch on/off the speaker mode during a call by pressing the loudspeaker key
once and shortly - (see
If you hang up the receiver in the speaker mode, the call will be finished. You can switch from
speaker mode to handsfree operation by pressing the loudspeaker key a longer period of
time (approx. 2 seconds).
During speaker mode the following symbol is presented on the display:
.
With help of the plus/minus keys you can change the volume in the loudspeaker during
speaker mode.
☞
Advice
☞
Advice