JLG G12-55A AccuPlace Service Manual User Manual
Page 155
Advertising
9.37
G10-55A & G12-55A AccuPlace
Electrical System
b. Disassembly
DO NOT disassemble the dash switch. Replace a
defective switch with a new part.
c. Inspection and Replacement
Inspect the switch terminals for continuity and shorting in
both the engaged and disengaged positions. Replace a
defective or faulty switch with a new switch.
d. Switch Installation
1. Connect the switch to the cab harness connector.
2. Position the switch over the rectangular switch bezel
and snap into position.
3. Connect the battery negative (-) cable to the battery
negative (-) terminal.
4. Start the machine and check the replaced switch for
proper function.
5. Close and secure the engine cover.
Advertising
This manual is related to the following products: