JLG G12-55A AccuPlace Service Manual - Manual (Page 80)

Engine
7.2 G10-55A & G12-55A AccuPlace
7.1 INTRODUCTION
7.1.1 Disclaimer and Scope
These instructions are written for worldwide use. In
territories where legal requirements govern engine smoke
emission, noise, safety factors, etc., apply all instructions,
data and dimensions provided herein in such a way that
after maintenance, service and repair of the engine,
engine operation does not violate local regulations.
Note: These instructions cover only the routine
maintenance, removal, installation and troubleshooting
of the engine. Refer to the local Engine Distributor and
the applicable Engine Service Manual for assistance
with comprehensive engine diagnosis, repair and
component replacement. A gradual running-in (break-in)
of a new engine is not necessary. Full load can be
applied to a new engine as soon as the engine is put into
service and the coolant temperature is at least
140° F (60° C). Extended light-load operation during the
early life of the engine is not recommended. DO NOT run
the engine at high, no-load speeds. DO NOT apply an
overload to the engine.