JLG G12-55A AccuPlace Service Manual - Manual (Page 185)

9.67 G10-55A & G12-55A AccuPlace
Electrical System
LEFT
STABILIZER
JOYSTICK – OUT
OF RANGE HIGH 2363 The Left Stabilizer joystick
voltage has reached the high
error limit defined in
Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Left
Stabilizer joystick and an adjacent Mini
Joystick to determine whether the Left
Stabilizer joystick is faulty. If the joystick is
fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2128.
Check continuity of wiring connections.
LEFT
STABILIZER
JOYSTICK – OUT
OF RANGE LOW 2364 The Left Stabilizer joystick
voltage has reached the low
error limit defined in
Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Left
Stabilizer joystick and an adjacent Mini
Joystick to determine whether the Left
Stabilizer joystick is faulty. If the joystick is
fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2128.
Check continuity of wiring connections.
RIGHT
STABILIZER
JOYSTICK –
NEUTRAL
DISAGREEMENT 2365 The Right Stabilizer joystick
is within its deadband and
one of the directional
switches is closed or the
joystick is outside its
deadband and the
respective directional switch
is not closed; debounce 2
seconds. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Right
Stabilizer joystick and an adjacent Mini
Joystick to determine whether the Left
Stabilizer joystick is faulty. If the joystick is
fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2129.
Check continuity of wiring connections.
RIGHT
STABILIZER
JOYSTICK – OUT
OF RANGE HIGH 2366 The Right Stabilizer joystick
voltage has reached the high
error limit defined in
Personalities. N Center joystick and check to see if a power
cycle will clear DTC.
If not, swap connector between Right
Stabilizer joystick and an adjacent Mini
Joystick to determine whether the Left
Stabilizer joystick is faulty. If the joystick is
fine, focus troubleshooting efforts on the
connector and wiring as detailed in DTC
2129.
Check continuity of wiring connections.
Help Message
1
DTC Fault Condition
(for configurable items,
fault applies only if
configured)
Fault
Requires
AccuPlace
Reset?
Action(s)