ElmoMC SimplIQ Digital Servo Drives-Bell Command Reference - Manual (Page 106)

LP[N] - List Properties
Purpose:
Sets the properties of the non-volatile data upload and download by the next LS and
DL commands.
LP[1] sets the start byte address of the next LS transmission, or the byte
address for starting the storage of the next DL transmission.
LP[2] sets the size — in bytes — to be transmitted at the next LS.
LP[3] returns the start byte address of the user program (read only).
LP[4] returns the size of the user program storage (read only).
Attributes: Type: Parameter, Integer
Scope: RS-232, CANopen
Restrictions: None
Default values:
LP[1] and LP[2] set to 0 on power on
Range: LP[1]: [0…262,144]
LP[2]: [0…247]
Index range: [1…4]
Unit modes: All
Activation: Immediate
SimplIQ: Similar
Under most circumstances, this command is used only by the Elmo Studio.
See also:
CC , DL , LS
SimplIQ Programming and Language Guide
SimplIQ for Steppers Command Reference Manual Alphabetical Listing
MAN-STECR (Ver. 1.1)
98