ElmoMC SimplIQ Digital Servo Drives-Bell Command Reference - Manual (Page 9)

Chapter 1: Introduction
This manual describes, in detail, each software command used to manipulate the SimplIQ
for Steppers line of digital servo drives. It is an integral part of the SimplIQ for Steppers
documentation set, which includes:
The Bell Stepper Drive Installation Guide, which provides full instructions for
installing a drive.
The Composer User Manual, which includes explanations of all the software tools that
are a part of Elmo’s Composer software environment.
The SimplIQ for Steppers has been derived from Elmo's SimplIQ interface. Most of the
commands and explanations are identical. There are, however, some changes, following
the introduction of stepper capabilities. We have tried to keep the changes minimal.
The following diagram illustrates the available SimplIQ for Steppers documentation.
Note: This command reference does not describe commands that are only
intended for service vendor-supplied tuning and setup tools.
Commands that are normally used by service vendor-supplied tuning and setup
tools, but in some situations may be used by advanced users, are marked with this
"Wizard's wand" symbol.
SimplIQ for Steppers Command Reference Manual Introduction
MAN-STECR (Ver. 1.1)
1