Panel/wall mounting – Rockwell Automation 1440-VSE02-01RA XM-122 gSE Vibration Module User Manual
Page 26
Advertising
Publication GMSI10-UM013D-EN-P - May 2010
16 Installing the XM-122 gSE Vibration Module
5. Gently push the side connector into the side of the neighboring terminal
base to complete the backplane connection.
Panel/Wall Mounting
Installation on a wall or panel consists of:
•
laying out the drilling points on the wall or panel
•
drilling the pilot holes for the mounting screws
•
installing the terminal base units and securing them to the wall or panel
Use the following steps to install the terminal base on a wall or panel.
Advertising