Rockwell Automation 1440-VSE02-01RA XM-122 gSE Vibration Module - Manual (Page 51)

Publication GMSI10-UM013D-EN-P - May 2010
Installing the XM-122 gSE Vibration Module 41
Figure 2.29 Velocity Sensor and Two Non-contact Sensor Wiring
IMPORTANT
Transducer DC bias is monitored on all signals.
IMPORTANT
A jumper from terminal 22 to terminal 21 is required for
channel 2 buffered output. Refer to Configuring Buffered
Output Input Range on page 28.
TYPICAL WIRING FOR COIL-BASED VELOCITY SENSOR AND TWO
NON-CONTACT SENSORS TO XM-122 VIBRATION MODULE
Pin A - Common
Pin B - Signal
Cable shield not
connected at this end
Shield
0
16 Channel 1 Input Signal
Signal Common
SIG
-24
COM
SIG
-24
COM
17
1
Signal Common
Channel 2 Input Signal
21
22
-24V DC
20
-24V DC
4
Signal Common
Tach Input Signal
36
13
31
Shield
Shield
*
* Note: Jumpering terminal 22 to
terminal 21 configures
CH 2 buffer (-24V to 9V)
18