Terminal block assignments – Rockwell Automation 1440-VSE02-01RA XM-122 gSE Vibration Module User Manual
Page 28
Publication GMSI10-UM013D-EN-P - May 2010
18 Installing the XM-122 gSE Vibration Module
Figure 2.7 XM-940 Terminal Base Unit
Terminal Block Assignments
The terminal block assignments and descriptions for the XM-122 module are
shown below.
ATTENTION
The terminal block assignments are different for different
XM modules. The following table applies only to the
XM-122 module revision D01 (and later). If you have an
earlier revision of the module, refer to Appendix D for its
terminal block assignments.
Refer to the installation instructions for the specific XM
module for its terminal assignments.
TIP
The XM module’s revision number is on the product label
(which is located on the front of the XM module, as shown
below).
XM-940 (Cat. No. 1440-TB-A)
Revision number
of XM module