Connecting a process dc voltage signal – Rockwell Automation 1440-VSE02-01RA XM-122 gSE Vibration Module User Manual
Page 46
Publication GMSI10-UM013D-EN-P - May 2010
36 Installing the XM-122 gSE Vibration Module
Connecting a Process DC Voltage Signal
The following figures show the wiring from a process DC voltage signal to the
terminal base unit.
Figure 2.25 DC Voltage Signal to Channel 1 Wiring
ATTENTION
You may ground the cable shield at either end of the cable.
Do not ground the shield at both ends. Recommended
practice is to ground the cable shield at the terminal base
and not at the transducer. Any convenient Chassis terminal
may be used (see Terminal Block Assignments on page 18).
IMPORTANT
The module does not power the sensor. It measures only
the input voltage.
TYPICAL WIRING FOR PROCESS DC VOLTAGE SIGNAL
TO XM-122 VIBRATION MODULE CHANNEL 1
Cable shield not
connected at this end
Shield
0
16
Channel 1 Input Signal
Signal Common
37
Process DC
Source