Kontron NSC2U IP Network Server - Manual (Page 20)

NSC2U Server—Features
Kontron IP Network Server NSC2U
Product Guide, rev. 1.4 December 2009
20
2.7 Hard Disk Drives
The NSC2U Server chassis supports up to six hot-swappable hard drive tray assemblies
at the front of the chassis.
For information on how to install these drives, see Section 3.3.1, “Installing or
Replacing a Hard Drive” .
Note: The NSC2U Server does not support all SAS hard drives. For a list of validated hard
drive manufacturers and hard drive types, see the Tested Hardware and Operating
Systems List (THOL) at
http://us.kontron.com/support/ (Search for NSC2U, click on Product Downloads, then
Compatibility Matrix.)
Drives can consume up to 17W of power each. Drives must be specified to run at a
maximum ambient temperature of 45°C.
2.8 Riser Card Assembly
The IP Network Server NSC2U incorporates a PCI riser assembly that supports
installation of PCI-X and PCI Express add-in boards. The assembly includes two riser
cards that provide a total of five standard interface slots for add-in boards by
connecting to two special slots on the T5000PAL server board.
• One of the riser card slots is a PCI super slot that contains all the signals necessary
to support both PCI-X and PCI Express (PCIe) expansion slots. The riser card that
connects to the super slot supports the connection of full-height, full-length PCI-X
or PCIe add-in cards.
Description Description
A BIOS Bank Select Jumper P CPU Power Connector
B IO Module Option Connector Q Main Power Connector
C POST Code Diagnostic LEDs R Battery
D Intel ® Adaptive Slot – Full-height S Power Supply Management Connector
E PCI Express Riser Slot – Low-profile T Dual Port USB 2.0 Header
F System Identification LED - Blue U Serial Port Connector
G External I/O Connectors V SSI 24-pin Control Panel Header
H Status LED – Green/Amber W
Intel ® Remote Management Module (RMM)
Connector
I Serial ‘B’ Port Configuration Jumper X System Recovery Jumper Block
J FBDIMM Slots Y Chassis Intrusion Switch Header
K CPU #1 Connector Z 3-pin IPMB Header
L CPU #2 Connector AA Intel ® Local Control Panel Header
M Voltage Regulator Heat Sink BB Serial ‘A’ Header
N Bridge Board Connector CC Intel ® RMM NIC Connector
O
ATA-100 Optical Drive Connector
(power and I/O)
Note: In Figure 7 , connectors shown but not called out are “not used”.