4 installing the front bezel, 5 removing the processor air duct, Installing the front bezel – Kontron NSC2U IP Network Server User Manual

Page 27: Removing the processor air duct

Advertising
background image

Kontron IP Network Server NSC2U

December 2009

Product Guide, rev. 1.4

27

Server Component Installations and Upgrades—NSC2U Server

2. Remove the bezel retention screw (right side, if present). (“A”)
3. Rotate the bezel outward as shown and remove. (“B”)

3.2.4

Installing the Front Bezel

1. Align the four tabs on the left of the bezel with the slots in the front panel and then

rotate the free end of the bezel to the closed position.

2. Snap the front bezel into place and tighten the screw at the right edge of the bezel

(if used).

3. Re-connect the 4xGbE cables if they are used.

3.2.5

Removing the Processor Air Duct

The air duct must be removed to access the processors, memory DIMMs, CPU fan

assembly, the SFP board, or the inside of the front panel. The processor air duct is

required for proper airflow within the chassis. Be sure the air duct is in place again

before installing the chassis cover.

1. Power down the server system and unplug all peripheral devices and the AC power

cable.

2. Remove the chassis cover. For instructions, see

Section 3.2.1

,

“Removing the

Chassis Cover”

.

3. Slide the duct several millimeters toward the rear panel until it stops. (“A”)
4. Lift the air duct straight up and remove it from the chassis. (“B”)

Figure 10.

Removing the Front Bezel

TS000272

A

B

Advertising