Kontron NSC2U IP Network Server - Manual (Page 59)

Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
59
Optional Component Installations—NSC2U Server
2. With the riser card assembly lying upside down, remove the filler panel for the full-
height PCIe slot you will be using for the LAN card. ( Figure 41 , “A”)
3. Loosen the blue thumbscrew on the retention clip and rotate the clip outward.
(“B”)
Disengage the three plastic tabs from the metal sidewall.
4. Slide the LAN card onto the sheet metal and attach it to the selected full-height
PCI-Express riser card slot connector. (“C”)
5. Fasten the LAN card to the riser card assembly bracket using the rear retention
screw. (“D”)
4.5.2 Configuring the RJ45 GbE LAN Card
Caution: When handling the LAN card, observe the normal safety and ESD precautions. (See
Appendix A, “Safety Information” for more information.
1. Insert the GbE cables through the side bracket of the LAN card. ( Figure 42 , “A”)
2. Drape the LED cable over the side bracket, not through it like the GbE cables. (“B”)
3. Connect the four GbE cables to the LAN card with the colors installed in the
following order as shown in Figure 42 :
4. Connect the LED ribbon cable to the LAN card connector with the red stripe on the
side farthest away from the board’s edge connector. (“F” and “G”)
Figure 41. Installing the LAN Card into the Riser Assembly
B
D
A
TS000320
C
B Yellow
C Blue
D White
E Red