Kontron NSC2U IP Network Server - Manual (Page 53)

Kontron IP Network Server NSC2U
December 2009 Product Guide, rev. 1.4
53
Optional Component Installations—NSC2U Server
4.2.2 Removing the PCI Riser Card Assembly
To remove the riser card assembly from the chassis, follow these steps:
1. Grasp the PCI riser card assembly using the two flexible blue handles. (“A”)
2. Place a finger on the PCI Fan Assembly so that it will not be moved. (“B”)
3. Carefully lift the assembly out of the chassis. (“C”)
4.2.3 Removing an Add-in Card from the Riser Card Assembly
Caution: When handling an add-in card, observe the normal safety and ESD precautions. (See
Appendix A, “Safety Information” for more information.)
1. Turn the riser card assembly upside-down to remove the add-in card.
2. Remove the rear retention screw that fastens the riser card to the rear bracket.
(“A” or “D)
3. When removing a full-height add-in card, remove the front retention clip by
loosening the blue captive screw and rotating the clip outward. (“B”)
Disengage the three plastic tabs from the metal sidewall.
4. Remove the add-in card from the riser card socket. (“C” or “E”)
Figure 34. Removing the Riser Card Assembly
TS000545
B
C
A