Cisco ASA 5505 User Manual
Page 146
3-26
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 3 Managing Feature Licenses
Information About Feature Licenses
•
“Failover and Shared License Participants” section on page 3-27
Failover and Shared License Servers
This section describes how the main server and backup server interact with failover. Because the shared
licensing server is also performing normal duties as the ASA, including performing functions such as
being a VPN gateway and firewall, then you might need to configure failover for the main and backup
shared licensing servers for increased reliability.
Note
The backup server mechanism is separate from, but compatible with, failover.
Shared licenses are supported only in single context mode, so Active/Active failover is not supported.
For Active/Standby failover, the primary unit acts as the main shared licensing server, and the standby
unit acts as the main shared licensing server after failover. The standby unit does not act as the backup
shared licensing server. Instead, you can have a second pair of units acting as the backup server, if
desired.
For example, you have a network with 2 failover pairs. Pair #1 includes the main licensing server. Pair
#2 includes the backup server. When the primary unit from Pair #1 goes down, the standby unit
immediately becomes the new main licensing server. The backup server from Pair #2 never gets used.
Only if both units in Pair #1 go down does the backup server in Pair #2 come into use as the shared
licensing server. If Pair #1 remains down, and the primary unit in Pair #2 goes down, then the standby
unit in Pair #2 comes into use as the shared licensing server (see
).