Cisco ASA 5505 - Manual (Page 951)

46-5
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 46 Configuring Inspection for Management Application Protocols
GTP Inspection
• timeout signaling 0:30:00
• timeout tunnel 0:01:00
• tunnel-limit 500
To create and configure a GTP map, perform the following steps. You can then apply the GTP map when
you enable GTP inspection according to the
“Configuring Application Layer Protocol Inspection”
section on page 42-6 .
Step 1 Create a GTP inspection policy map, enter the following command:
hostname(config)# policy-map type inspect gtp policy_map_name
hostname(config-pmap)#
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
Step 2 (Optional) To add a description to the policy map, enter the following command:
hostname(config-pmap)# description string
Step 3 To match an Access Point name, enter the following command:
hostname(config-pmap)# match [not] apn regex [regex_name | class regex_class_name]
Step 4 To match a message ID, enter the following command:
hostname(config-pmap)# match [not] message id [message_id | range lower_range upper_range]
Where the message_id is an alphanumeric identifier between 1 and 255. The lower_range is lower range
of message IDs. The upper_range is the upper range of message IDs.
Step 5 To match a message length, enter the following command:
hostname(config-pmap)# match [not] message length min min_length max max_length
Where the min_length and max_length are both between 1 and 65536. The length specified by this
command is the sum of the GTP header and the rest of the message, which is the payload of the UDP
packet.
Step 6 To match the version, enter the following command:
hostname(config-pmap)# match [not] version [version_id | range lower_range upper_range]
Where the version_id is between 0and 255. The lower_range is lower range of versions. The
upper_range is the upper range of versions.
Step 7 To configure parameters that affect the inspection engine, perform the following steps:
a. To enter parameters configuration mode, enter the following command:
hostname(config-pmap)# parameters
hostname(config-pmap-p)#
The mnc network_code argument is a two or three-digit value identifying the network code.
By default, the security appliance does not check for valid MCC/MNC combinations. This command
is used for IMSI Prefix filtering. The MCC and MNC in the IMSI of the received packet is compared
with the MCC/MNC configured with this command and is dropped if it does not match.