Cisco ASA 5505 - Manual (Page 257)

6-15
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 6 Starting Interface Configuration (ASA 5510 and Higher)
Starting Interface Configuration (ASA 5510 and Higher)
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/5
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
nameif mgmt
security-level 100
ip address 10.1.1.5 255.255.255.0
no shutdown
!
interface Management0/1
shutdown
no nameif
no security-level
no ip address
Step 5 Above each pasted command section, create your new logical interfaces by entering one of the following
commands:
• interface redundant number [1-8]
• interface port-channel channel_id [1-48]
For example:
...
interface port-channel 1
nameif outside
security-level 0
ip address 10.86.194.225 255.255.255.0
no shutdown
!
interface port-channel 2
nameif inside
security-level 100
ip address 192.168.1.3 255.255.255.0
no shutdown
!
interface port-channel 3
nameif mgmt
security-level 100
ip address 10.1.1.5 255.255.255.0
no shutdown
Step 6 Assign the physical interfaces to the new logical interfaces:
• Redundant interface—Enter the following commands under the new interface redundant
command:
member-interface physical_interface1
member-interface physical_interface2
Where the physical interfaces are any two interfaces of the same type (either formerly in use or
unused). You cannot assign a Management interface to a redundant interface.
For example, to take advantage of existing cabling, you would continue to use the formerly in-use
interfaces in their old roles as part of the inside and outside redundant interfaces: