Cisco ASA 5505 - Manual (Page 1793)

79-13
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 79 Configuring SNMP
Information About SNMP
ceSensorExtThresholdNotification
(CISCO-ENTITY-SENSOR-EXT-MIB)
Note Not supported on the
ASA Services Module.
ceSensorExtThresholdValue,
entPhySensorValue,
entPhySensorType,
entPhysicalName The snmp-server enable traps entity
[power-supply-failure | fan-failure |
cpu-temperature] command is used to
enable transmission of the entity
threshold notifications. This notification
is sent for a power supply failure. The
objects sent identify the fan and CPU
temperature.
The snmp-server enable traps entity
fan-failure command is used to enable
transmission of the fan failure trap.
The snmp-server enable traps entity
power-supply-failure command is used
to enable transmission of the power
supply failure trap.
The snmp-server enable traps entity
chassis-fan-failure command is used to
enable transmission of the chassis fan
failure trap.
The snmp-server enable traps entity
cpu-temperature command is used to
enable transmission of the high CPU
temperature trap.
The snmp-server enable traps entity
power-supply-presence command is
used to enable transmission of the power
supply presence failure trap.
The snmp-server enable traps entity
power-supply-temperature command is
used to enable transmission of the power
supply temperature threshold trap.
The snmp-server enable traps entity
chassis-temperature command is used
to enable transmission of the chassis
ambient temperature trap.
cipSecTunnelStart
(CISCO-IPSEC-FLOW-MONITOR-MIB)
cipSecTunLifeTime,
cipSecTunLifeSize The snmp-server enable traps ipsec
start command is used to enable
transmission of this trap.
cipSecTunnelStop
(CISCO-IPSEC-FLOW-MONITOR-MIB)
cipSecTunActiveTime The snmp-server enable traps ipsec
stop command is used to enable
transmission of this trap.
ciscoRasTooManySessions
(CISCO-REMOTE-ACCESS-MONITOR
-MIB)
crasNumSessions, crasNumUsers,
crasMaxSessionsSupportable,
crasMaxUsersSupportable,
crasThrMaxSessions The snmp-server enable traps
remote-access
session-threshold-exceeded command is
used to enable transmission of these
traps.
Table 79-5 Supported Traps (Notifications) (continued)