Cisco ASA 5505 - Manual (Page 599)

30-17
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 30 Configuring Network Object NAT
Configuration Examples for Network Object NAT
Step 4 Create a network object for the outside web server:
hostname(config)# object network myWebServ
Step 5 Define the web server address:
hostname(config-network-object)# host 209.165.201.12
Step 6 Configure static NAT for the web server:
hostname(config-network-object)# nat (outside,inside) static 10.1.2.20
Inside Load Balancer with Multiple Mapped Addresses (Static NAT,
One-to-Many)
The following example shows an inside load balancer that is translated to multiple IP addresses. When
an outside host accesses one of the mapped IP addresses, it is untranslated to the single load balancer
address. Depending on the URL requested, it redirects traffic to the correct web server. (See
Figure 30-3 ).
Figure 30-3 Static NAT with One-to-Many for an Inside Load Balancer
Step 1 Create a network object for the addresses to which you want to map the load balancer:
Host
Outside
Inside
Load Balancer
10.1.2.27
Web Servers
Undo Translation
10.1.2.27 209.165.201.3
Undo Translation
10.1.2.27 209.165.201.4
Undo Translation
10.1.2.27 209.165.201.5
248633