Cisco ASA 5505 - Manual (Page 17)

Contents
xvii
Cisco ASA 5500 Series Configuration Guide using the CLI
C H A P T E R
22 Configuring Static and Default Routes 22-1
Information About Static and Default Routes 22-1
Licensing Requirements for Static and Default Routes 22-2
Guidelines and Limitations 22-2
Configuring Static and Default Routes 22-2
Configuring a Static Route 22-3
Adding or Editing a Static Route 22-3
Configuring a Default Static Route 22-4
Limitations on Configuring a Default Static Route 22-4
Configuring IPv6 Default and Static Routes 22-5
Monitoring a Static or Default Route 22-6
Configuration Examples for Static or Default Routes 22-8
Feature History for Static and Default Routes 22-8
C H A P T E R
23 Defining Route Maps 23-1
Information About Route Maps 23-1
Permit and Deny Clauses 23-2
Match and Set Clause Values 23-2
Licensing Requirements for Route Maps 23-3
Guidelines and Limitations 23-3
Defining a Route Map 23-4
Customizing a Route Map 23-4
Defining a Route to Match a Specific Destination Address 23-4
Configuring the Metric Values for a Route Action 23-5
Configuration Example for Route Maps 23-6
Feature History for Route Maps 23-6
C H A P T E R
24 Configuring OSPF 24-1
Information About OSPF 24-1
Licensing Requirements for OSPF 24-2
Guidelines and Limitations 24-3
Configuring OSPF 24-3
Customizing OSPF 24-4
Redistributing Routes Into OSPF 24-4
Configuring Route Summarization When Redistributing Routes Into OSPF 24-6
Configuring Route Summarization Between OSPF Areas 24-7
Configuring OSPF Interface Parameters 24-8