Cisco ASA 5505 - Manual (Page 1510)

67-84
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 67 Configuring Connection Profiles, Group Policies, and Users
Configuring User Attributes
The parameter values for this command are as follows:
• IPsec—Negotiates an IPsec tunnel between two peers (a remote access client or another secure
gateway). Creates security associations that govern authentication, encryption, encapsulation, and
key management.
• webvpn—Provides clientless SSL VPN access to remote users via an HTTPS-enabled web browser,
and does not require a client
Enter this command to configure one or more tunneling modes. You must configure at least one tunneling
mode for users to connect over a VPN tunnel.
The following example shows how to configure clientless SSL VPN and IPsec tunneling modes for the
user named anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# vpn-tunnel-protocol webvpn
hostname(config-username)# vpn-tunnel-protocol IPsec
hostname(config-username)
Restricting Remote User Access
Configure the group-lock attribute with the value keyword to restrict remote users to access only
through the specified, preexisting connection profile. Group-lock restricts users by checking whether the
group configured in the VPN client is the same as the connection profile to which the user is assigned.
If it is not, the ASA prevents the user from connecting. If you do not configure group-lock, the ASA
authenticates users without regard to the assigned group.
To remove the group-lock attribute from the running configuration, enter the no form of this command.
This option allows inheritance of a value from the group policy. To disable group-lock, and to prevent
inheriting a group-lock value from a default or specified group policy, enter the group-lock command
with the none keyword.
hostname(config-username)# group-lock {value tunnel-grp-name | none}
hostname(config-username)# no group-lock
hostname(config-username)
The following example shows how to set group lock for the user named anyuser:
hostname(config)# username anyuser attributes
hostname(config-username)# group-lock value tunnel-group-name
hostname(config-username)
Enabling Password Storage for Software Client Users
Specify whether to let users store their login passwords on the client system. Password storage is
disabled by default. Enable password storage only on systems that you know to be in secure sites. To
disable password storage, enter the password-storage command with the disable keyword. To remove
the password-storage attribute from the running configuration, enter the no form of this command. This
enables inheritance of a value for password-storage from the group policy.
hostname(config-username)# password-storage {enable | disable}
hostname(config-username)# no password-storage
hostname(config-username)
This command has no bearing on interactive hardware client authentication or individual user
authentication for hardware clients.
The following example shows how to enable password storage for the user named anyuser: