Cisco ASA 5505 - Manual (Page 217)

5-17
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter 5 Configuring Multiple Context Mode
Configuring Multiple Contexts
Detailed Steps
Table 5-1 Resource Names and Limits
Resource Name
Rate or
Concurrent
Minimum and
Maximum Number
per Context
System Limit 1
1. If this column value is N/A, then you cannot set a percentage of the resource because there is no hard system limit for the resource.
Description
mac-addresses Concurrent N/A 65,535 For transparent firewall mode, the number of
MAC addresses allowed in the MAC address
table.
conns Concurrent
or Rate N/A Concurrent connections:
See the
“Supported
Feature Licenses Per
Model” section on
page 3-1
for the
connection limit for your
platform.
Rate: N/A
TCP or UDP connections between any two
hosts, including connections between one
host and multiple other hosts.
inspects Rate N/A N/A Application inspections.
hosts Concurrent N/A N/A Hosts that can connect through the ASA.
asdm Concurrent 1 minimum
5 maximum
200 ASDM management sessions.
Note ASDM sessions use two HTTPS
connections: one for monitoring that
is always present, and one for making
configuration changes that is present
only when you make changes. For
example, the system limit of 32
ASDM sessions represents a limit of
64 HTTPS sessions.
ssh Concurrent 1 minimum
5 maximum
100 SSH sessions.
syslogs Rate N/A N/A Syslog messages.
telnet Concurrent 1 minimum
5 maximum
100 Telnet sessions.
xlates Concurrent N/A N/A Address translations.
Command Purpose
Step 1 class name
Example:
hostname(config)# threat-detection
scanning-threat shun except ip-address
10.1.1.0 255.255.255.0
Specifies the class name and enters the class configuration mode.
The name is a string up to 20 characters long. To set the limits for
the default class, enter default for the name.
Step 2 Do one or more of the following: