Teac GigaStudio 3 - Manual (Page 200)

200 201
Off (--) The EQ band is bypassed and inactive.
Parametric (BL) Enables a Band Limiting type of EQ. Gain, Frequency, and Q (width)
controls are available.
Notch (NO) Enables a Notch type (narrow band) type of EQ. Only the Frequency and Q
(width) controls are available.
Low Pass (LP) Enables a high frequency filter type of EQ. Only the Frequency control is
available for adjusting the cutoff point.
High Pass (HP) Enables a low frequency filter type of EQ. Only the Frequency control is
available for adjusting the cutoff point.
Low Shelf (LS) Enables a low frequency roll off type of EQ. Only the Gain and Frequen-
cy controls are available.
High Shelf (HS) Enables a low frequency roll off type of EQ. Only the Gain and Fre-
quency controls are available.
Gain dB
Adjust the GAIN dB slider control for the selected EQ band. Right-click
the slider to set a MIDI control. A text display below the slider indicates
the gain setting in dB (decibels), which ranges from -15 to +15 dB.
Frequency
Adjust the FREQ Hz slider control for the selected EQ band. Right-click
the slider to set a MIDI control. A text display below the slider indicates
the frequency setting in Hz (cycles per second), which ranges from 16 to
21K.
Q (width)
Adjust the Q slider control for the selected EQ band. Right-click the
slider to set a MIDI control. A text display below the slider indicates the
width setting controlling the broadness of the spectrum of the signal
surrounding the frequency defined by the FREQ Hz control. The range of
this control is from 1 (most narrow setting) to 36 (widest setting).