Watson-Marlow MM420 - Manual (Page 96)

3 Functions Issue 10/06
MICROMASTER 420 Operating Instructions
96 6SE6400-5AA00-0BP0
3.6.4 Analog output (DAC)
Number: 1
Parameter range:
r0770 – P0785
Function chart number: FP2300
Features:
- cycle time:
4 ms
- resolution: 10 bit
- accuracy: 1 % referred to 20 mA
Setpoints, actual values and control signals inside the drive inverter are read-out
via the D/A converter using these analog input. The digital signal is converted into
an analog signal. All of the signals can be output via the D/A which contain the
"CO" abbreviation in the parameter text (refer to list of all of the BICO parameters
in the parameter list). Parameter P0771 defines, by assigning the parameter
number, the quantity which is output as analog signal through the DAC channel
(refer to Fig. 3-27). The smoothed output frequency is output, e.g. via the analog
output, if P0771 = 21.
D/A conv.
channel
D
A
KL
KL
D/A conv. −
D/A conv.+ r0755 Pxxxx rxxxx P0771
...
Function
r0020 CO: Freq. setpoint before RFG
r0021 CO: Act. filtered frequency
r0024 CO: Act. filtered output freq.
r0025 CO: Act. filtered output voltage
r0026 CO: Act. filtered DC-link volt.
r0027 CO: Act. filtered output current
r0052 CO/BO: Act. status word 1
r0053 CO/BO: Act. status word 2
r0054 CO/BO: Act. control word 1
...
0
... 20 m
A
Fig. 3-27 Signal output through the DAC channel
In order to adapt the signal, the DAC channel has several function units (filter,
scaling, dead zone) which can be used to modify the digital signal before
conversion (refer to Fig. 3-28).
P07
77
P07
78
P07
79
P07
80
Fig. 3-28 DAC channel