H3C Technologies H3C S12500 Series Switches User Manual

Page 168

Advertising
background image

157

[SwitchB-vlan2] port Gigabitethernet 3/0/5

[SwitchB-vlan2] quit

[SwitchB] interface vlan-interface 2

[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0

# Create a VRRP group 1 and set its virtual IP address to 202.38.160.111.

[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111

# Configure the authentication mode of the VRRP group as simple and authentication key as hello.

[SwitchB-Vlan-interface2] vrrp vrid 1 authentication-mode simple hello

# Set the interval for master to send VRRP advertisement to 4 seconds.

[SwitchB-Vlan-interface2] vrrp vrid 1 timer advertise 4

# Configure Switch B to operate in preemptive mode, so that Switch B can become the master after
the priority of Switch A decreases to a value lower than 100. Configure the preemption delay as

5 seconds to avoid frequent status switchover.

[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5

3.

Verify the configuration:
After the configuration, Host B can be pinged successfully on Host A. To verify your configuration,

use the display vrrp verbose command.
# Display the detailed information of VRRP group 1 on Switch A.

[SwitchA-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Vlan-interface2

VRID : 1 Adver Timer : 4

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : Simple Key : ******

Virtual IP : 202.38.160.111

Virtual MAC : 0000-5e00-0101

Master IP : 202.38.160.1

VRRP Track Information:

Track Interface: Vlan3 State : Up Pri Reduced : 30

# Display the detailed information of VRRP group 1 on Switch B.

[SwitchB-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Vlan-interface2

VRID : 1 Adver Timer : 4

Admin Status : Up State : Backup

Config Pri : 100 Running Pri : 100

Preempt Mode : Yes Delay Time : 5

Become Master : 2200ms left

Auth Type : Simple Key : ******

Advertising
This manual is related to the following products: