H3C Technologies H3C S12500 Series Switches User Manual

Page 91

Advertising
background image

80

# Enable RRPP.

[DeviceD] rrpp enable

5.

Configure Device E:
# Create VLANs 1 through 30, map these VLANs to MSTI 1, and activate the MST region
configuration.

<DeviceE> system-view

[DeviceE] vlan 1 to 30

[DeviceE] stp region-configuration

[DeviceE-mst-region] instance 1 vlan 1 to 30

[DeviceE-mst-region] active region-configuration

[DeviceE-mst-region] quit

# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 3/0/1 and
GigabitEthernet 3/0/2, disable the spanning tree feature, configure the two ports as trunk ports,

and assign them to VLANs 1 through 30.

<DeviceE> system-view

[DeviceE] interface gigabitethernet 3/0/1

[DeviceE-GigabitEthernet3/0/1] link-delay 0

[DeviceE-GigabitEthernet3/0/1] undo stp enable

[DeviceE-GigabitEthernet3/0/1] port link-type trunk

[DeviceE-GigabitEthernet3/0/1] port trunk permit vlan 1 to 30

[DeviceE-GigabitEthernet3/0/1] quit

[DeviceE] interface gigabitethernet 3/0/2

[DeviceE-GigabitEthernet3/0/2] link-delay 0

[DeviceE-GigabitEthernet3/0/2] undo stp enable

[DeviceE-GigabitEthernet3/0/2] port link-type trunk

[DeviceE-GigabitEthernet3/0/2] port trunk permit vlan 1 to 30

[DeviceE-GigabitEthernet3/0/2] quit

# Create RRPP domain 1, configure VLAN 4092 as the primary control VLAN of RRPP domain 1,

and configure VLANs mapped to MSTI 1 as the protected VLANs of RRPP domain 1.

[DeviceE] rrpp domain 1

[DeviceE-rrpp-domain1] control-vlan 4092

[DeviceE-rrpp-domain1] protected-vlan reference-instance 1

# Configure Device E as the master node of subring 2, with GigabitEthernet 3/0/1 as the primary
port and GigabitEthernet 3/0/2 as the secondary port, and enable ring 2.

[DeviceE-rrpp-domain1] ring 2 node-mode master primary-port gigabitethernet 3/0/1

secondary-port gigabitethernet 3/0/2 level 1

[DeviceE-rrpp-domain1] ring 2 enable

[DeviceE-rrpp-domain1] quit

# Enable RRPP.

[DeviceE] rrpp enable

6.

Verify the configuration:
Use the display command to view RRPP configuration and operational information on each device.

Advertising
This manual is related to the following products: