H3C Technologies H3C S12500 Series Switches User Manual

Page 165

Advertising
background image

154

[SwitchB-vlan2] quit

[SwitchB] interface vlan-interface 2

[SwitchB-Vlan-interface2] ip address 202.38.160.2 255.255.255.0

# Create VRRP group 1 and set its virtual IP address to 202.38.160.111.

[SwitchB-Vlan-interface2] vrrp vrid 1 virtual-ip 202.38.160.111

# Set Switch B to operate in preemptive mode. The preemption delay is 5 seconds.

[SwitchB-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5

3.

Verify the configuration:
After the configuration, Host B can be pinged successfully on Host A. To verify your configuration,
use the display vrrp verbose command.
# Display the detailed information of VRRP group 1 on Switch A.

[SwitchA-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Vlan-interface2

VRID : 1 Adver Timer : 1

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : None

Virtual IP : 202.38.160.111

Virtual MAC : 0000-5e00-0101

Master IP : 202.38.160.1

# Display the detailed information of VRRP group 1 on Switch B.

[SwitchB-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface Vlan-interface2

VRID : 1 Adver Timer : 1

Admin Status : Up State : Backup

Config Pri : 100 Running Pri : 100

Preempt Mode : Yes Delay Time : 5

Become Master : 4200ms left

Auth Type : None

Virtual IP : 202.38.160.111

Master IP : 202.38.160.1

The output shows that in VRRP group 1 Switch A is the master, Switch B is the backup and packets

sent from Host A to Host B are forwarded by Switch A.
When Switch A fails, you can still ping through Host B on Host A. Use the display vrrp verbose
command to view the detailed information of the VRRP group on Switch B.
# When Switch A fails, the detailed information of VRRP group 1 on Switch B is displayed.

[SwitchB-Vlan-interface2] display vrrp verbose

IPv4 Standby Information:

Advertising
This manual is related to the following products: