RIGOL M300 - Manual (Page 26)

RIGOL Chapter 2 Command System
Programming Guide for DM3000 2-14
:MEASure:CURRent:AC MAX
25. :MEASure:CURRent:AC:RANGe?
Syntax
:MEASure:CURRent:AC:RANGe?
Function Query the range of AC current measurement.
The query returns 0, 1, 2 or 3.
26. :MEASure:CURRent:AC:DIGIt
Syntax
:MEASure:CURRent:AC:DIGIt?
:MEASure:CURRent:AC:DIGIt {INC|DEC|5|6|7}
Function Set the display digit of AC current measurement value.
Explanation Refer to the “Explanation” in :MEASure:VOLTage:DC:DIGIt.
Example
Set the display digit of AC current measurement value to 6:
:MEASure:CURRent:AC:DIGIt 6
Decrease the display digit by one:
:MEASure:CURRent:AC:DIGIt DEC
27. :MEASure:CURRent:AC:FREQuency?
Syntax
:MEASure:CURRent:AC:FREQuency?
Function The query returns the frequency of AC current measurement in
scientific notation (for example, +5.30803456e+02) and the unit is Hz.
Explanation The multimeter should work under the AC current measurement mode
while you use this command.
28. :MEASure:CURRent:AC:FREQuency:DISPlay
Syntax
:MEASure:CURRent:AC:FREQuency:DISPlay
Function Display the frequency of the AC signal on the secondary screen (lower
left) during AC current measurement.
Explanation The multimeter should work under the AC voltage measurement mode
when you use this command.
29. :MEASure:CURRent:AC:FREQuency:HIDE
Syntax
:MEASure:CURRent:AC:FREQuency:HIDE
Function Hide the frequency on the secondary screen during AC current
measurement.
Explanation The command is valid only when the frequency display on the