RIGOL M300 - Manual (Page 74)

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000 3-8
[SENSe:]FREQuency:RANGe:LOWer
{<filter>|MIN|MAX|DEF} 200. The “DEF” is 20.
[SENSe:]FREQuency:VOLTage:RANGe:AUTO
?
[SENSe:]FREQuency:VOLTage:RANGe:AUTO
<mode>
Query and set the state of the voltage auto range
function of frequency measurement.
[SENSe:]FREQuency:VOLTage:RANGe[:UPPe
r]? [{MIN|MAX}]
[SENSe:]FREQuency:VOLTage:RANGe[:UPPe
r] {<voltage_range>|MIN|MAX|DEF}
Query and set the voltage range of frequency
measurement.
[SENSe:]FRESistance:APERture?
[{MIN|MAX}]
[SENSe:]FRESistance:APERture
{<second>|MIN|MAX|DEF} Query and set the aperture time of 4-wire resistance
measurement.
Note: DM3000 only receives this command but
does not response to it.
[SENSe:]FRESistance:NPLC? [{MIN|MAX}]
[SENSe:]FRESistance:NPLC
{<PLCs>|MIN|MAX|DEF}
Query and set the aperture time of 4-wire resistance
measurement. The input value and return value are
both multiples of PLC.
Note: DM3000 only receives this command but
does not support the NPLC value setting function.
[SENSe:]FRESistance:NULL[:STATe]?
[SENSe:]FRESistance:NULL[:STATe]
{ON|OFF}
Query and set the state of the NULL function of
4-wire resistance measurement.
[SENSe:]FRESistance:NULL:VALue?
[{MIN|MAX}]
[SENSe:]FRESistance:NULL:VALue
{<value>|MIN|MAX}
Query and set the NULL value of 4-wire resistance
measurement.
[SENSe:]FRESistance:RANGe:AUTO?
[SENSe:]FRESistance:RANGe:AUTO <mode> Query and set the state of the auto range function
of 4-wire resistance measurement.
[SENSe:]FRESistance:RANGe[:UPPer]?
[{MIN|MAX}]
[SENSe:]FRESistance:RANGe[:UPPer]
{<range>|MIN|MAX|DEF}
Query and set the range of 4-wire resistance
measurement.
[SENSe:]FRESistance:RESolution?
[{MIN|MAX}]
[SENSe:]FRESistance::RESolution
{<resolution>|MIN|MAX|DEF}
Query and set the reading resolution of 4-wire
resistance measurement.
[SENSe:]FUNCtion[:ON]? Query and set the current measurement function of