RIGOL M300 - Manual (Page 4)

RIGOL
Programming Guide for DM3000 II
In This Manual
This manual provides guidance for the remote control of DM3000 series digital
multimeter. It is assumed that readers of this manual have read DM3000 User’s Guide
and are familiar with the operation methods of DM3000.
The manual contains four parts:
Chapter 1
This chapter introduces you how to use SCPI commands to control the DM3000 series
multimeter via remote interfaces.
Chapter 2
This chapter gives detailed information on each command supported by
DM3000
series multimeter.
Chapter 3
This chapter lists the commands which are compatible with
RIGOL DM3000 series
multimeter in table form.
Appendix
The Appendix lists all the commands alphabetically in favor of quick reference.
Explanation:
DM3000 series digital multimeter consists of the following models. The main
differences among the models are as listed in the table below.
Series Model Digit Interface
DM306x
DM3064 6 ½ USB Host&Device, RS232, LAN, GPIB, Scan
DM3062 6 ½ USB Host&Device, RS232, LAN, GPIB
DM3061 6 ½ USB Host&Device, RS232
DM305x
DM3054 5 ¾ USB Host&Device, RS232, LAN, GPIB, Scan
DM3052 5 ¾ USB Host&Device, RS232, LAN, GPIB
DM3051 5 ¾ USB Host&Device, RS232
Unless otherwise noted, the contents in this manual are based on DM3064. For
different model, the value of parameter of some command differs.