RIGOL M300 - Manual (Page 82)

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000 3-16
Fluke Commands Compatibility
The following table lists the Fluke commands supported by RIGOL DM3000 series
digital multimeter. Before using these commands, please select the Fluke command
set using the CMDSet command (send the CMDSet FLUKE command). For more
details on this command, please refer to the “Command Set Introduction”on page 1-5.
Note: the functions of the Fluke commands in RIGOL DM3000 series digital
multimeter are listed in the “Function” column in the table below.
Fluke Command Function
AAC Enable the AC current measurement function.
ADC Enable the DC current measurement function.
VDC Enable the DC voltage measurement function.
VAC Enable the AC voltage measurement function.
CONT Enable the continuity measurement function.
DIODE Enable the diode measurement function.
FREQ Enable the frequency measurement function.
FREQ2
Enable the frequency measurement function on the secondary
display while the instrument is in AC measurement.
OHMS Enable the resistance measurement function.
WIRE2 Switch to the 2-wire resistance measurement function.
WIRE4 Switch to the 4-wire resistance measurement function.
FUNC1? Query the current main measurement function.
FUNC2?
Query the current secondary measurement function. It is only
available for AC measurement. For other measurement functions,
the query returns NULL.
CLR2
Clear the secondary function. This command is available only when
the frequency measurement function is enabled during AC
measurement.
DB Enable the DB measurement function.
DBCLR Exit the DB measurement function.
DBREF <value>
Set the DB reference value. The reference value corresponding to
the parameter is as shown in the table below. The unit of reference
resistance is dBm.