RIGOL M300 - Manual (Page 63)

Chapter 2 Command System RIGOL
Programming Guide for DM3000 2-51
:SCAN Commands
The commands are used to set the scan parameters for the instrument. The
commands include:
 :SCAN:PROJect?
 :SCAN:PROJect:CREAte
 :SCAN:PROJect:CURRently:CYCLe?
 :SCAN:TASK:ADD
 :SCAN:TASK:DELEte
 :SCAN:TASK:INTErval
 :SCAN:TASK:LIST?
 :SCAN:RUN?
 :SCAN:RUN
 :SCAN:STOP
 :SCAN:DATA?
 :SCAN:CARDid?
Note: the commands are only available for DM3054 and DM3064 with software
version 03.12.00.03.04.00.07 or higher.