RIGOL M300 - Manual (Page 75)

Chapter 3 Commands Compatibility RIGOL
Programming Guide for DM3000 3-9
[SENSe:]FUNCtion[:ON] "<function>" the instrument.
[SENSe:]MEASure:CAPacitance?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the capacitance measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for capacitance
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure:CONTinuity?
Reset all the continuity measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for continuity
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure:CURRent:AC?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the AC current measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for AC current
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure:CURRent[:DC]?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the DC current measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for DC current
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure:DIODe?
Reset all the diode measurement parameters and
trigger parameters to their defaults, and then
configure the multimeter for diode measurements.
Acquire the test result and send it to the output
buffer of the instrument.
[SENSe:]MEASure:FREQuency?
[{<range>|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the frequency measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for frequency
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure:FRESistance?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the 4-wire resistance measurement
parameters and trigger parameters to their defaults,
and then configure the multimeter for 4-wire
resistance measurement. Acquire the test result and
send it to the output buffer of the instrument.
[SENSe:]MEASure:PERiod? Reset all the period measurement parameters and