RIGOL M300 - Manual (Page 39)

Chapter 2 Command System RIGOL
Programming Guide for DM3000 2-27
1. :SYSTem:BEEPer
Syntax
:SYSTem:BEEPer
Function Cause the beeper to buzz once. This command is usually used to
test whether the beeper works normally.
Explanation Please enable the beeper before sending this command.
2. :SYSTem:BEEPer:STATe
Syntax
:SYSTem:BEEPer:STATe?
:SYSTem:BEEPer:STATe {ON|OFF|1|0}
Function Set the beeper state.
The query returns ON or OFF.
Default ON
3. :SYSTem:CONFigure:POWEron
Syntax
:SYSTem:CONFigure:POWEron {LAST|DEF}
Function Set the power-on configuration to LAST or DEF.
Default DEF
4. :SYSTem:CONFigure:DEFault
Syntax
:SYSTem:CONFigure:DEFault
Function Restore the instrument settings to default values.
5. :SYSTem:LANGuage
Syntax
:SYSTem:LANGuage?
:SYSTem:LANGuage {CHinese|ENglish}
Function Set the display language.
The query returns CHINESE or ENGLISH.
Default CHinese
6. :SYSTem:CLOCk:STATe
Syntax
:SYSTem:CLOCk:STATe?
:SYSTem:CLOCk:STATe {HIDE|DISPLay |1|0}
Function Set the display mode of system clock.
“DISPLay” and “1” denote displaying the clock on the multimeter
interface; “HIDE” and “0” denote hiding the clock.
The query returns DISPLAY or HIDE.
Default DISPLay