RIGOL M300 - Manual (Page 76)

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000 3-10
[{<range>|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]] trigger parameters to their defaults, and then
configure the multimeter for period measurement.
Acquire the test result and send it to the output
buffer of the instrument.
[SENSe:]MEASure:RESistance?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the 2-wire resistance measurement
parameters and trigger parameters to their defaults,
and then configure the multimeter for 2-wire
resistance measurement. Acquire the test result and
send it to the output buffer of the instrument.
[SENSe:]MEASure[:VOLTage]:AC?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the AC voltage measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for AC voltage
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEASure[:VOLTage][:DC]?
[{<range>|AUTO|MIN|MAX|DEF}
[,{<resolution>|MIN|MAX|DEF}]]
Reset all the DC voltage measurement parameters
and trigger parameters to their defaults, and then
configure the multimeter for DC voltage
measurement. Acquire the test result and send it to
the output buffer of the instrument.
[SENSe:]MEMory:NSTates?
Query the number of memory locations of system
configuration available.
[SENSe:]MEMory:STATe:CATalog?
Query the names of all the memory locations of
system configuration.
[SENSe:]MEMory:STATe:DELete
{1|2|3|4|5|6|7|8|9|10} Delete the contents in the specified memory
location of system configuration.
[SENSe:]MEMory:STATe:DELete:ALL
Delete the contents in all the memory locations of
system configuration.
[SENSe:]MEMory:STATe:NAME?
{1|2|3|4|5|6|7|8|9|10} Query the filename in the specified memory
location of system configuration.
[SENSe:]MEMory:STATe:RECall:AUTO?
[SENSe:]MEMory:STATe:RECall:AUTO
<mode>
Query and set the state of the auto recall function of
the specific state information at power-on.
[SENSe:]MEMory:STATe:VALid?
{1|2|3|4|5|6|7|8|9|10}
Query whether a system configuration available is
stored in the specified memory location of system
configuration.
[SENSe:]OUTPut:TRIGger:SLOPe?
[SENSe:]OUTPut:TRIGger:SLOPe <slope> Query and set the type (positive pulse or negative
pulse) of the output signal of the multimeter.