RIGOL M300 - Manual (Page 68)

RIGOL Chapter 3 Commands Compatibility
Programming Guide for DM3000 3-2
Agilent Commands Compatibility
The table below lists the
Agilent commands supported by RIGOL DM3000 series
digital multimeter. Before using the commands, please select the Agilent command set
using the CMDSet command (send the CMDSet AGILENT command). For more
details on this command, please refer to the “Command Set Introduction” in Chapter
1.
Note: the functions of the Agilent commands in RIGOL DM3000 series digital
multimeter are listed in the “Function” column in the table below.
Agilent Command Function
CALCulate:AVERage:AVERage?
Query the average of all the data in the statistic
operation.
CALCulate:AVERage:CLEar Disable the statistic function.
CALCulate:AVERage:COUNt? Query the number of statistic data.
CALCulate:AVERage:MAXimum? Query the maximum of the statistic data.
CALCulate:AVERage:MINimum? Query the minimum of the statistic data.
CALCulate:AVERage:PTPeak? Query the peak-peak value of the statistic data.
CALCulate:AVERage:SDEViation? Query the standard deviation of the statistic data.
CALCulate:DB:REFerence?
{MINimun|MAXimun}
CALCulate:DB:REFerence
{<value>|MINimum|MAXimum}
Query and set the dB reference value.
CALCulate:DBM:REFerence?
{MINimun|MAXimun}
CALCulate:DBM:REFerence
{<value>|MINimum|MAXimum}
Query and set the dBm reference value.
CALCulate:FUNCtion?
CALCulate:FUNCtion
{NULL|DB|DBM|AVERage|LIMit}
Query and set the math operation function.
CALCulate:LIMit:LOWer?
{MINimum|MAXimum}
CALCulate:LIMit:LOWer
{<value>|MINimum}
Query and set the lower limit of the current
measurement function.
CALCulate:LIMit:UPPer? Query and set the upper limit of the current