RIGOL M300 - Manual (Page 58)

RIGOL Chapter 2 Command System
Programming Guide for DM3000 2-46
:DATAlog Commands
The commands are used to set the datalog parameters of the instrument. The
commands include:
 :DATAlog:CONFigure?
 :DATAlog:CONFigure:FUNCtion
 :DATAlog:CONFigure:STARtmode
 :DATAlog:CONFigure:STARtmode:AUTO
 :DATAlog:CONFigure:STARtmode:EXTern
 :DATAlog:CONFigure:STARtmode:DELAytime
 :DATAlog:CONFigure:STOPmode:TIME
 :DATAlog:CONFigure:STOPmode:NUMber
 :DATAlog:CONFigure:RATE
 :DATAlog:RUN
 :DATAlog:RUN?
 :DATAlog:STOP
 :DATAlog:DATA?
Note: the commands are only available for DM3054 and DM3064 with software
version 03.12.00.03.04.00.07 or higher.