PLANET VIP-350PT User Manual
Page 68
[68/168]
[Del]: Delete one character.
[Abc..]/[123..]: Toggle between digits and alphanumeric input, where. [Abc..] indicates current input
method is alphanumeric and [123..] indicates digits input.
[Clear]: Clear all input.
1 .
M S
A C :
2 .
A n
o n y m
o
u
s
C
a
l
l
:
* 6 7
3 .
C L
I
P :
*
8
2
4 .
M W I
:
5 .
S
e
r
v e
r
H
o
l
d
:
6 .
C a
l
l
P
i
c
k
u
p
:
*
*
7 .
F
e
a
t
u r
e
C
o
d
e
0
:
8 .
F
e
a
t
u r
e
C
o
d
e
1
:
9 .
F
e
a
t
u r
e
C
o
d
e
2
:
Del
Abc../123..
Clear
Back
• Conference Server Access Code:
Whenever the [Conf] soft-key is pressed, IP Phone will try to initiate a 3-way local conferencing.
However, some ISP provide media server for server-side conference support as well. Thus, if you
want to send such access code to server, such as “*#”, instead of launch a local conference after
pressing [Conf] soft-key, you may define the access code here. If defined, this terminal will send
specified MSAC code as DTMF sequence by either inband or outband (rfc2833 or SIP INFO)
during conversation. Leave it blank for 3-way local conference on pressing [Conf] soft-key.
• CLIR: Calling Line Identification Restriction.
System default is to enable Calling Line Identification Presentation, CLIP, all the time. You may
enable the Call Line Identification Restriction, CLIR on a per-call basis by using the call command
dial string. To enable CLIR on a per-call basis requires that the dial string sequence (typically *67)
that users enter on their dial-pad prior to dialing the phone number match the specified CLIR string
defined in the call command. Whenever the prefix is detected in dial string, it will be stripped off
from the original dial string and send to proxy with CLIR enabled. The SIP INVITE message sent by
IP Phone would look like:
INVITE sip:[email protected] SIP/2.0
Via: SIP/2.0/UDP 192.168.3.253:5060;branch=abc7801
Via: SIP/2.0/UDP 192.168.3.51:5060
From: "Anonymous" <sip:[email protected]>
;tag=22516
To: <sip:[email protected]>
Call-ID: [email protected]
CSeq: 1 INVITE
Contact: "Anonymous" <sip:[email protected]:5060>
User-Agent: IP-Phone/2.0
Content-Length: 171
Content-Type: application/sdp
v=0
o=ipr000dc300051 0 0 IN IP4 192.168.3.5
System default activation code is “*67”.
• CLIP: Calling Line Identification Presentation.
System default is to enable Calling Line Identification Presentation, CLIP, all the time. You may
cancel CLIR by using the CLIP call command dial string.
To enable the Calling Line Identification Presentation, CLIR, on a per-call basis (to counter CLIR)
requires that the dial string sequence (typically *82) that users enter on their dial-pad prior to dialing
the phone number match the specified CLIP string defined in the call command. Whenever the
prefix is detected in dial string, it will be stripped off from the original dial string and send to proxy
with CLIP enabled.
System default activation code is “*82”.