Yokogawa YFGW710 - Manual (Page 123)

<C2. Field Wireless Configurator>
C2-2
IM 01W01F01-01EN
C2.2 Installation
C2.2.1 System Requirements
The PC used for installing the Field Wireless Configurator must meet the system requirements
indicated in “C1. System Requirements of Software Provided” in this manual.
C2.2.2 Installation Procedure
Administrator rights are required for installing the Field Wireless Configurator.
Before installing the Field Wirless Configurator, the Microsoft .NET framework 3.5 Service Pack
1 must be installed on the PC. If this has not been installed, install it from the DVD-ROM provided
first.
The Installation procedure or update procedure from older version is described in the Readme_
en.txt contained on the DVD-ROM.
If Microsoft .NET Framework 3.5 Service Pack 1 is not installed, install it according to the instruc-
tions given in the TIP below.
Follow the instructions in the TIP of “C1. System Requirements of Provided Software” to check if
Microsoft .NET Framework 3.5 Service Pack 1 is enabled under Windows Server 2008 R2.
If an old Field Wireless Configurator is installed, following the instructions below will install the
new version on top of the old version.
Set the DVD-ROM on the PC, and proceed to the following folder on Explorer.
<DVD-ROM drive> \Field Wireless Configurator
Run the “setup.exe” file from the above folder, and follow the wizard instructions.
Figure C 2-1
TIP
If Microsoft .NET Framework 3.5 Service Pack 1 has not been installed, run “setup.exe” to start Microsoft .NET
Framework 3.5 Service Pack 1 installation. Accept the Microsoft License Agreement to start installation of Micro-
soft .NET Framework 3.5 Service Pack 1.
When Service Pack 1 installation is completed, installation of the Field Wireless Configurator starts. Follow the
instructions given by the Wizard to complete installation.